Researchers led by Deepak Kapa, with Shishir Kolathaya among the authors, have designed BiPathCPG, a gearbox for the quasi-direct-drive actuators used in legged robots, according to a paper accepted by IEEE Robotics and Automation Letters and posted on arXiv. Compound planetary gearboxes balance efficiency and torque, but usual designs make 3D-printed actuators wider, heavier and less stiff.

BiPathCPG adds an idle second-stage sun gear and second-stage planet gears that share the load, placed in space a conventional design leaves unused. An optimisation framework works out the gearbox parameters for a given motor and gear ratio.

A 3D-printed prototype, tested on custom rigs against a conventional compound planetary gearbox, reached a torsional stiffness of 1,394 Nm/rad, 1.7 times higher, with 32% less backlash, 25 g less mass and an axial width about 6.4 mm smaller. Its peak stall torque was 36.49 Nm.

Source: arXiv Robotics (cs.RO)

Background

Deepak Kapa

Robotics researcher

Robotics researcher.